Chemforce TED (5L): The Efflorescence Destroyer, Removes Effloresence, dried grout & concrete

Benefits of TED™

• Highly concentrated formulation. Contains 50 to 60% Urea Hydrochloride
• Powerful but much lower fuming than hydrochloric acid.
• Effectively removes mineral residues, including efflorescence, grout haze, rust marks, soap scum, limescale, mortar mess.
• Acidic Cleaner can also be used for removing fireplace soot.
• Temporary contact does not immediately burn skin – you have some time to rinse off the Acidic Cleaner (however, rinse immediately after skin contact).
• Almost no corrosion of metals, except aluminium.

HOW TO USE

1. Read Product Data Sheet and Material Safety Data Sheet before using.
2. Wear protective gloves/protective clothing/eye protection/face protection.
3. TEST PRODUCT ON A SMALL AREA TO CHECK ACID SENSITIVITY BEFORE FULL APPLICATION.
4. If satisfied with test results, remove all loose dust and dirt from the surface.
5. Apply when surface temperature is 5 to 35 °C (40 – 95 °F).
6. Pre-wet very porous surfaces with water to prevent cleaner penetrating too deeply.
7. TED™ is highly concentrated and must be diluted with clean water. Recommended dilutions:
   • Efflorescence, rust marks – 1 part TED™ to 10 parts water
   • Grout haze, limescale, soap scum – 1 part TED™ to 20 parts water
8. Pour, brush or spray mixed solution generously onto surface and leave for 3 minutes.
9. Do not allow solution to dry on surface.
10. Clean large areas in sections.
11. Rub with a white nylon scrub pad, or similar, to clean the surface.
12. TED™ is highly acidic and must be neutralized before rinsing: Use Oxitec-M™ or dissolve 1 cup of bicarbonate of soda in a bucket of water. Pour, spray over the entire surface and leave for minimum 3 minutes.
13. Rinse surface thoroughly several times with clean water.
    NOTE: TED™ is highly acidic and will etch acid sensitive materials such as marble, limestone, travertine and onyx. Concrete should be wet before applying TED™ and neutralized immediately afterwards to minimize damage.

SHELF LIFE AND STORAGE GUIDELINES

Best within 2 years of manufacture date. Store away from direct sunlight.

Keep container tightly sealed, in a well-ventilated place, at 2-300 Celsius / 36-850 Fahrenheit.

TRANSPORT

NOT CLASSIFIED AS A DANGEROUS GOOD BY THE CRITERIA OF THE ADG CODE, IMDG OR IATA

PACK SIZES

• 1L (1.06Q); 5L (1.3G); 20L (5.3G)

TECHNICAL DATA

• • Specific Gravity: 1.21
  • Colour: Clear colourless to light straw yellow liquid
  • Weight: 1L (1.06Q) = 1.3Kg (2.86Lb.); 5L (1.3G) = 6.3Kg (13.9Lb), 20L (5.3G) = 25Kg (55Lb),

COUNTRY OF MANUFACTURE

Australia