|Refractory Material – Hard||●||●●|
|Hard||Hard Clay Pavers||●||●●||●●|
|Medium||Refractory Material – Med/Soft||●||●●|
|Concrete -Medium Hard||●●||●●||●●|
|Concrete – Green||●●||●●|
Abrasive resistant bond for extended life on soft/abrasive materials.
Used on concrete and asphalt. Viewed as general purpose.
Semi-Pro bond for use on hard to medium, non-abrasive materials.
High speed cutting on hard/ very hard,non abrasive material.
● Suitable – The blade life or cutting speed could vary. ●● Recommended – Ideally suitable for this application.
|Directions for use:|
|●||Blade must have the correct arbour to fit the machine spindle. Ensure flanges are clean and of equal size. Turn by hand to check the blade turns true.|
|●||Always use safety goggles, ear muffs and protective clothing|
|●||Always make sure the machine is fitted with safety guards|
|●||Ensure blade is fitted correctly by checking that the arrow on the blade spins in the same direction as the machine rotation.|
|●||Pre-sharpen blade with shallow cuts in soft, abrasive material (eg. sandstone)|
|●||For normal cutting, multiple shallow cuts are better than single deep cuts. Do not force the blade. Do not side grind|
|●||Use light pressure. Forcing or twisting blade in cutting can cause loss of sharpness, excess wear, overheating, distortion and segment damage.|
Diameters of 500mm and above are available on request.